|Shanghai Qunjie Machinery Equipment Co., Ltd.|
Shanghai group Jay Machinery Equipment Co., Ltd.
Shanghai Qunjie Machinery Equipment Co., Ltd.
Technical department: 13661534086
Sales one: 15921556613
Sales Department 2: 13524508868
Mr. Chen: 15900972501
Company switchboard: 021-59501335
Address: A-1611, 200 First Road, Baoshan District, Shanghai
Portable industrial hot air blower structure: There is air flow from the blower, and the gas enters the heater and passes evenly from both sides of the spiral heating wire. In this process, the hot air is fully implemented. The temperature of the relevant hot air is abnormal. A temperature, such as 150 ° C, may be set by yourself. A thermocouple is installed on the air outlet. When the air outlet temperature is lower than 150 ° C, the heater will always be employed, so that the air temperature of the air outlet will continue to increase. When the temperature reaches 150 ℃, the heater stops working. The residual temperature will make the air outlet temperature go back and forth around 150 ℃. The temperature control accuracy is ± 1 ℃. When the air outlet temperature is lower than 149 ℃, the heater will continue to be employed, which is the air outlet temperature. Maintenance is around 150 ° C, the difference between left and right will not preempt ± 1 ° C. The air volume of the fan can be adjusted. Generally, the air volume of the low power may be controlled by the air door, and the high power or the correct wind control may be equipped with an inverter on the fan to control the air volume.
Portable industrial hot air blower uses: The air blower itself is small in size and light in weight. A private person may wish to send the difference and the workpiece is heated and dried. Some commonly used venues are: general site that requires air or hot air. , Heating up, and so on, to give a few simple examples like the rapid drying of workpieces in the electroplating industry and industrial cleaning industry; forming and annealing processes during glass making; drying and dehydration of material particles in injection molding and extrusion industries; coating industry Heating up before painting, rapid drying of the coating after painting, etc.